Legs Go Numb After Taumatic Accident

construction of a bolt pistol, Part 2 and: Entnerfizierung, paint and reassemble

Continued from construction of a bolt pistol, Part 1
The Entnerfizierung

The removal of decals and logos was relatively simple. With a file roughly weggefeilt everything and then smoothed with a scraper. After that, all traces were removed.
The whole thing lasted less than 15 minutes

The painting
The painting was a bit nasty, because the basement where all I did was poorly ventilated.
The metallic color I was much too bright, so I darkened the paint with irregular bursts "Chaos Black" by GW.

Assembly

The assembly went very well, screwed up was completed on the date on which all. Then I noticed this is not the drum turned. So screwed back, looked up, it was all right. Funny so screwed back and ... Drum roll ... It did not work again ... Shit! So
thought, pondered, and then the screws near the rotational mechanism a little loose and viola! The drum was spinning.

Tomorrow evening I will still worried after I had done a few decorations, the decorations and the finish.